Now the light is on a little too long, but it works. So I use: alias: Lichter Flur Bewegungsmelder ausĮntity_id: binary_adfri_motion_sensor But the Ikea motion sensor need 30seconds to go on after it goes off. My aqara motion sensor did not change the status to on after changing it to off (no motion) when I use this code: alias: Lichter Flur Bewegungsmelder aus With this code: alias: Lichter Flur Bewegungsmelder aus Then it should be checked again whether someone is moving and so on. Then it takes another 2 minutes and the motion sensor changes back to no motion. What I want: if the status of the motion sensor changes to no motion, wait 10 seconds to see whether motion is detected again. However, if a person is in this area, the light always goes out and you have to move again so that it comes on again. The lights go off when the motion sensor change the state to no motion. When I use this code: alias: Lichter Flur Bewegungsmelder aus But if motion is detected again, there is no further check. If no more motion is detected within 20 seconds, this code works. Here my code: alias: Lichter Flur Bewegungsmelder aus This is to ensure that the light does not go out all the time when you stay in this area for a long time, but only when no one is there or no longer moves. If motion is detected again within these 10 seconds a check should only be carried out again if no motion has been detected for 10 seconds and so on. I want a motion sensor to turn off the lights if it has not detected motion for 10 seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |